1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by kunicksbak

  1. kunicksbak
    Post

    Solved Prints come out slightly angled or stretched

    Trying to get dual extrusion working with Kisslicer, seems i have everyhting set properly, but the extruders are greyed out when i go to select them.
    Post by: kunicksbak, Oct 6, 2019 in forum: Troubleshooting
  2. kunicksbak
    Post

    Raspberry Pi and display dead

    Thank you @RetireeJay. I just assumed it was configured correctly. When you mentioned that I decided to look for myself. That board had M212...
    Post by: kunicksbak, Oct 4, 2019 in forum: Troubleshooting
  3. kunicksbak
    Post

    PID tuning and Marlin

    I tried with Safari installed on other Pc with Windows 10 and another with windows 7 pro, same result: templates with dividers are distorted Has...
    Post by: kunicksbak, Oct 2, 2019 in forum: General Questions
  4. kunicksbak
    Post

    I'm ready to buy my first 3d printer

    Very nice first prints. Glad to have another Printrbot enthusiast here and it seems you have plenty of 3d design knowledge which can go a long...
    Post by: kunicksbak, Sep 30, 2019 in forum: Introduction