1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Lance Weston
Last Activity:
Oct 12, 2024 at 8:44 AM
Joined:
Jun 2, 2018
Messages:
672
Likes Received:
235
Trophy Points:
43

Followers 2

Gender:
Male

Share This Page

Lance Weston

Active Member, Male

Lance Weston was last seen:
Oct 12, 2024 at 8:44 AM
    1. Bill Humbert
      Bill Humbert
      i have rebuilt my R2 and printed a few objects that came out well. Problem is i get binding when it goes through the bed level sensing process. I have gone through the alignment process many times in a variety of ways. I feel like if i could slow the move speed during the level process it would be okay. Can I modify the movement speed in firmware? or point me to someone or an article than can?
  • Loading...
  • About

    Gender:
    Male