1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by latreides

  1. latreides
    Post

    Considering buying a ROBO 3D R1+

    I've been troubleshooting it for the past two months. I have leveled the bed (very manually with spacers and a little less manually with a bed...
    Post by: latreides, May 11, 2017 in forum: General Questions
  2. latreides
    Post

    Considering buying a ROBO 3D R1+

    So my choice right now is between the R1 and the C2. I am leaning towards the C2 (I am considering buying one today) but I worry about two things...
    Post by: latreides, May 11, 2017 in forum: General Questions
  3. latreides
    Post

    Considering buying a ROBO 3D R1+

    No, 5" is minimum. The parts that I print just barely fit on my existing 4.9 inch bed (with little to no room for a brim), thanks for the...
    Post by: latreides, May 11, 2017 in forum: General Questions
  4. latreides
    Post

    Considering buying a ROBO 3D R1+

    If the bed size wasn't an issue (5" is plenty for my uses) would you recommend the R1+ or the C2? I have serious issues with adhesion and I have...
    Post by: latreides, May 10, 2017 in forum: General Questions
  5. latreides
    Post

    Considering buying a ROBO 3D R1+

    I am still doing research to figure out which printer to upgrade to, and the Robo R1+ has stayed at the top of my list, but I have some concerns....
    Post by: latreides, May 10, 2017 in forum: General Questions
  6. latreides
    Thread

    Considering buying a ROBO 3D R1+

    I am looking to buy a new 3d printer, and the ROBO R1+ has caught my eye. Some review sites have it in their top 3 (if not #1) for printers less...
    Thread by: latreides, Apr 16, 2017, 25 replies, in forum: General Questions