1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Lazytron

  1. Lazytron
    Post

    Tightening the extruder assembly?

    Yellow is the part that's moving, red is the interface point I was talking about. Not urgent at the moment since I just had my bed cable burn out =/
    Post by: Lazytron, Mar 12, 2025 in forum: Troubleshooting
  2. Lazytron
    Thread

    Tightening the extruder assembly?

    Hey all, it seems like the extruder assembly is a bit loose even with all of the screws I can find tightened down well. The vertical plastic block...
    Thread by: Lazytron, Feb 27, 2025, 3 replies, in forum: Troubleshooting
  3. Lazytron
    Thread

    Display drivers?

    Moved to a default octoprint image a while back. Decided to try to set up OctoDash to make babysitting a little easier. Screen doesnt seem to have...
    Thread by: Lazytron, Jan 5, 2025, 1 replies, in forum: Software
  4. Lazytron
    Thread

    Bearing size/part number

    Looks like I found the real source of my layer shift issues. Anyone know what the outside bearing for the large rails is so I can replace?
    Thread by: Lazytron, Sep 12, 2024, 1 replies, in forum: Troubleshooting
  5. Lazytron
    Post

    Layer shifting Y-Axis

    Awesome, I'll grease the rails and see if that helps. Any STLs or suppliers for the housings? If I'm going to have to pull them anyway I'd like...
    Post by: Lazytron, Jul 12, 2024 in forum: Troubleshooting
  6. Lazytron
    Post

    Layer shifting Y-Axis

    Here's what I was calling the slider, looks like the plastic tab just gave up but it seems otherwise intact. Is that what you mean by "bearing" or...
    Post by: Lazytron, Jul 12, 2024 in forum: Troubleshooting
  7. Lazytron
    Post

    Layer shifting Y-Axis

    Yep
    Post by: Lazytron, Jul 12, 2024 in forum: Troubleshooting
  8. Lazytron
    Thread

    Layer shifting Y-Axis

    Suddenly getting some pretty severe irregular layer shifts (several mm) on the Y axis. Just checked and all of the gears seem tight, they're...
    Thread by: Lazytron, Jul 11, 2024, 9 replies, in forum: Troubleshooting
  9. Lazytron
    Post

    Fan voltages?

    Checked it with meter earlier, looks like very slightly overdriven 12v/0.15a - i got some 12v/.6a replacements that should hold up!
    Post by: Lazytron, Jul 11, 2024 in forum: General Questions
  10. Lazytron
    Thread

    Fan voltages?

    Are all of the part/heatsink fans on the extruder end 12v? Just had the heatsink fan die and a couple of places mention of 24v (most of those in...
    Thread by: Lazytron, Jul 4, 2024, 8 replies, in forum: General Questions