1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Mirko3D

  1. Mirko3D
    Post

    ROBO 3D Spray Shield

    I now have dual fan ducts with 40x40x20 fans. The spray shield still works well with that mod. I do have to take the carriage up to 80mm now to...
    Post by: Mirko3D, Apr 1, 2016 in forum: Show and Tell
  2. Mirko3D
    Post

    ROBO 3D Spray Shield

    They are two separate pieces. There is no setup time. Just put'em in. Spray. Pull'em out. Tada! The only thing that may take a moment is...
    Post by: Mirko3D, Mar 28, 2016 in forum: Show and Tell
  3. Mirko3D
    Post

    ROBO 3D Spray Shield

    It's two pieces. I printed one a night. Depending on the settings you use it's about 6-7 per piece.
    Post by: Mirko3D, Mar 28, 2016 in forum: Show and Tell
  4. Mirko3D
    Thread

    ROBO 3D Spray Shield

    Hello, Here's the first thing that I want to show off. It's a spray shield for the ROBO 3D. I use hairspray on my bed and windex to clean it....
    Thread by: Mirko3D, Mar 28, 2016, 7 replies, in forum: Show and Tell
  5. Mirko3D
    Post

    Solved Error:Extruder switched off. Temperature fell too much during print!

    After checking all of the extruder thermistor wiring, I did two prints totalling 14 hours and did not have a temp fail. Yay! I'm still not sure...
    Post by: Mirko3D, Mar 28, 2016 in forum: Troubleshooting
  6. Mirko3D
    Post

    Unresolved Robo R1+ prints not centering on y axis as shown in Mattercontrol

    I too am seeing this issue. It happened with MatterControl and Simplify3D. At least in S3D you can adjust the Y position to center the print on...
    Post by: Mirko3D, Mar 27, 2016 in forum: Troubleshooting
  7. Mirko3D
    Post

    Solved Error:Extruder switched off. Temperature fell too much during print!

    I measured the resistance and got about 93k Ω. The ambient air temperature is about 25C. I'm not sure what resistance value to expect. I don't...
    Post by: Mirko3D, Mar 27, 2016 in forum: Troubleshooting
  8. Mirko3D
    Post

    Solved Error:Extruder switched off. Temperature fell too much during print!

    Great. So I haven't even had my printer for a week and the thermistor is already bad. How often do these things go bad? I have seen the post...
    Post by: Mirko3D, Mar 27, 2016 in forum: Troubleshooting
  9. Mirko3D
    Post

    Solved Error:Extruder switched off. Temperature fell too much during print!

    Hi Mark, Thank you for your reply. If you look at the output that I included you will see that the extruder temperature reading before the error...
    Post by: Mirko3D, Mar 27, 2016 in forum: Troubleshooting
  10. Mirko3D
    Thread

    Solved Error:Extruder switched off. Temperature fell too much during print!

    Hello! I've been having issues with failed prints due to errors with the extruder temperature (shown in red below). Even though it looks as if...
    Thread by: Mirko3D, Mar 27, 2016, 11 replies, in forum: Troubleshooting