Recent Content by PXLGEAR

Post

Hello, my z-offset is between 5.0 and 5.2 when i run the wizard those times when it wasnt working,the prints im currently running where sliced on...

Post by: PXLGEAR, Jan 16, 2017 in forum: Troubleshooting

Post

thank you for reply, on this robo c2 i only found 3 switches each pertaining to x,y,z axis and they were all ok secure and actuated normally.i did...

Post by: PXLGEAR, Jan 16, 2017 in forum: General Questions

Post

Yes i ran the z-offset wizard multiple times, i was unable to print the test key chain and the wavy vase test models.but i uploaded my own test...

Post by: PXLGEAR, Jan 16, 2017 in forum: Troubleshooting

Thread

does anyone know hot to fix the auto bed leveling.its pin pointing about 5mm above the bed and starts to print the supplied sample prints about...

Thread by: PXLGEAR, Jan 15, 2017, 36 replies, in forum: Troubleshooting

Thread

does anyone know how to repair the auto bed leveling? its pin pointing in mid air about 5mm above the bed.print starts printing about 2mm above...

Thread by: PXLGEAR, Jan 15, 2017, 4 replies, in forum: General Questions