1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Red7s

  1. Red7s
    Post

    Answered Consistent Layer Shifting

    I don't think I can make this belt much tighter. I've gone ahead and have tightened a zip tie around the belt as tight as possible..and have even...
    Post by: Red7s, Jan 27, 2019 in forum: Troubleshooting
  2. Red7s
    Post

    Answered Consistent Layer Shifting

    Thank you very much, Im messing with zip ties currently to try and get it tight enough! I will report back as I mess with it throughout the day....
    Post by: Red7s, Jan 26, 2019 in forum: Troubleshooting
  3. Red7s
    Post

    Answered Consistent Layer Shifting

    How would I go about tightening either of those? I checked around google and I can't seem to find any instructions on that. Or am I just bad at...
    Post by: Red7s, Jan 25, 2019 in forum: Troubleshooting
  4. Red7s
    Post

    Answered File download and printing

    Might be a dumb question, but did you make sure to arrange the model on the print bed before slicing? Sometimes when I import models within my...
    Post by: Red7s, Jan 25, 2019 in forum: Troubleshooting
  5. Red7s
    Thread

    Answered Consistent Layer Shifting

    I've had my R1 for almost 2 months now, after I bought it second hand off of Facebook marketplace..and I still have yet to get a successful print...
    Thread by: Red7s, Jan 25, 2019, 8 replies, in forum: Troubleshooting
  6. Red7s
    Post

    Newly Installed E3D v6 Doesn't Heat Up Properly

    So, anything above 1.1.5 will work on my R1 even though they are stated that they are for the + varient?
    Post by: Red7s, Jan 11, 2019 in forum: Mods and Upgrades
  7. Red7s
    Post

    Newly Installed E3D v6 Doesn't Heat Up Properly

    Great to hear, thank you very much! One more question if you do not mind. Is 1.1.5 the latest Marlin Firmware around for the R1 series that I...
    Post by: Red7s, Jan 11, 2019 in forum: Mods and Upgrades
  8. Red7s
    Post

    Newly Installed E3D v6 Doesn't Heat Up Properly

    To confirm, what I have currently will work than eventually and it's normal that it was taking 40+ minutes to heat up to 200c(assuming it didn't...
    Post by: Red7s, Jan 11, 2019 in forum: Mods and Upgrades
  9. Red7s
    Post

    Newly Installed E3D v6 Doesn't Heat Up Properly

    Thank you very much! I've just gone ahead and ordered a 12v heater core. I hope this fixes it(im sure it will) It should be here Sunday
    Post by: Red7s, Jan 11, 2019 in forum: Mods and Upgrades
  10. Red7s
    Thread

    Newly Installed E3D v6 Doesn't Heat Up Properly

    I recently installed an E3D V6 to a R1 I that I just bought off of Facebook Marketplace, that I later learned had a bad Thermistor due to it...
    Thread by: Red7s, Jan 11, 2019, 13 replies, in forum: Mods and Upgrades