1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Rescue35

  1. Rescue35
    Post

    Solved Temp Fail

    Follow up: The IR images showed the extruder was up to temp the whole time even when the display had the temp dropping. A $6000 FLIR IR camera is...
    Post by: Rescue35, Jul 29, 2016 in forum: Troubleshooting
  2. Rescue35
    Post

    Solved Temp Fail

    I snagged an IR picture of it just before failing. I will have to do a thorough test once I return home Saturday. The controller said the Temp was...
    Post by: Rescue35, Jul 12, 2016 in forum: Troubleshooting
  3. Rescue35
    Thread

    Solved Temp Fail

    At random points, during a print, I get a 10° C drop in extruder temp causing an error and my print to stop. This only happens after the auto...
    Thread by: Rescue35, Jul 11, 2016, 6 replies, in forum: Troubleshooting
  4. Rescue35
    Post

    Unresolved TEMP FALL ERROR

    I managed to get decent prints from ABS but I am in the process of switching over to PETG. To keep the edges from lifting on ABS I used a Raft...
    Post by: Rescue35, Jul 11, 2016 in forum: Troubleshooting
  5. Rescue35
    Post

    Unresolved TEMP FALL ERROR

    I hope you have it figured out. I am currently facing the same problem out of my R1. Thank you for sharing, I'll start a thread documenting my...
    Post by: Rescue35, Jul 11, 2016 in forum: Troubleshooting