1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by S1hane

  1. S1hane
    Post

    Anyone feel like sharing some pics!!

    I'm brand new to this and I understand it's very cheap to buy. So that's basically how I got started with it. Most of the parts I'm making I am...
    Post by: S1hane, Oct 7, 2018 in forum: Show and Tell
  2. S1hane
    Post

    Answered VIDEO: R1+ front X axis rod bearing dragging, possibly needs replacement?

    I think it might be off center. Thanks so much for your help! I'll let you know what happens.
    Post by: S1hane, Oct 7, 2018 in forum: Troubleshooting
  3. S1hane
    Post

    Anyone feel like sharing some pics!!

    New to this. Yeah I have some hatchbox ABS and it's pretty low (210c) temp recommended. I read folks have an easier time with the higher temp ABS...
    Post by: S1hane, Oct 7, 2018 in forum: Show and Tell
  4. S1hane
    Post

    Answered VIDEO: R1+ front X axis rod bearing dragging, possibly needs replacement?

    Good question! So I took off the belt and moved it around some. I know the motor adds some resistance to it but I can't distinguish if there's...
    Post by: S1hane, Oct 7, 2018 in forum: Troubleshooting
  5. S1hane
    Thread

    Answered VIDEO: R1+ front X axis rod bearing dragging, possibly needs replacement?

    So I just got this R1+ and it's been pretty fun to mess with so far. The problem I am trying to solve right now has to do with the front x axis...
    Thread by: S1hane, Oct 7, 2018, 5 replies, in forum: Troubleshooting
  6. S1hane
    Post

    Answered ok, why am i getting burn filament globs

    I've had this same problem, reducing the extruder temp and making sure the extruder multiplier calibration was correct pretty much eliminated it....
    Post by: S1hane, Oct 7, 2018 in forum: Troubleshooting
  7. S1hane
    Post

    Answered PLA Shrinking Inward on Circular Perimeters

    Have you tried a big ol' fan? I did the dual 40mm black widow fans on my R1+ and it really helped with my PLA prints
    Post by: S1hane, Oct 7, 2018 in forum: Troubleshooting
  8. S1hane
    Post

    Anyone feel like sharing some pics!!

    @Geoff Is that amazonbasics ABS filament? How do you like it?
    Post by: S1hane, Oct 7, 2018 in forum: Show and Tell
  9. S1hane
    Post

    Solved X-Axis Layer Shift

    Is there some kind of check you can do on the steppers using an ohm meter or multimeter?
    Post by: S1hane, Oct 7, 2018 in forum: Troubleshooting
  10. S1hane
    Post

    Answered Robo R1 heater for bed

    I got the 350w meanwell power supply and it works great for my R1+
    Post by: S1hane, Oct 7, 2018 in forum: Troubleshooting