Separate names with a comma.
Hello everyone. Noticed many of you have been wanting to turn your robo 3d R1 + printer dual extrusion but had not know how or been able to. Today...
I added the ramps and an lcd and nothing would happen
I had all the drivers in and thats it and it would still stop working after 30 plus seconds
i just replaced the ramps board
I just replaced the ramps and the arduino and it heated up in the same place and did the same thing. What should I do?
I checked and this only happens when the ramps is plugged in. what do you think?
I will turn on my arduino for about 20 seconds and the screen powers up and displays information. then the information will disappear and im...
I watched it and it didnt really help. honestly what do you think it is.
could it be an over heat issue, i dont have a fan next to it.
I think this may be due to the arduino over heating, any tips?
its LED 1