1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by seelenamt

  1. seelenamt
    Post

    Stepper Smoother

    Just to clarify- you are testing these on A4988 drivers? I'm not familiar with the R2 (I am using a R1), but I see a decent amount of back and...
    Post by: seelenamt, Mar 12, 2018 in forum: Off Topic
  2. seelenamt
    Post

    Community Favorite Marlin 1.1.7 Release for Robo R1, R1+PLUS & Variants

    Marlin 1.1.7 is now out. I was struggling with Marlin 1.1.5 (UBL stuff) on my R1 (not plus) before leaving it for a few months to focus on...
    Post by: seelenamt, Dec 16, 2017 in forum: Mods and Upgrades
  3. seelenamt
    Post

    Unresolved Homing/G28 issues

    It's the movement to the center of the bed that concerns me, though I really can't say if it's a real issue. If I just enter "G28" in the G-code...
    Post by: seelenamt, Jul 15, 2016 in forum: Troubleshooting
  4. seelenamt
    Post

    Unresolved Homing/G28 issues

    Sorry for the late response- I have now checked it both with octoprint and the terminal in the pronterface UI of cura. Typing the G28 command...
    Post by: seelenamt, Jul 12, 2016 in forum: Troubleshooting
  5. seelenamt
    Thread

    Unresolved Homing/G28 issues

    Hi all, I'm pretty new to the 3D printing stuff, and I've been trying to configure my Robo 3D R1 to get better quality/less failed prints- however...
    Thread by: seelenamt, Jul 9, 2016, 6 replies, in forum: Troubleshooting