1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by SnivyDroid

  1. SnivyDroid
    Post

    Solved Matter Control stuck on "Attempting to connect"

    on my windows, the IDE does the exact same thing with nothing attatched
    Post by: SnivyDroid, Nov 14, 2017 in forum: Troubleshooting
  2. SnivyDroid
    Post

    Solved Matter Control stuck on "Attempting to connect"

    the error always appears no matter if its plugged in to the printer or not
    Post by: SnivyDroid, Nov 14, 2017 in forum: Troubleshooting
  3. SnivyDroid
    Post

    Solved Matter Control stuck on "Attempting to connect"

    I tried them seperately.
    Post by: SnivyDroid, Nov 14, 2017 in forum: Troubleshooting
  4. SnivyDroid
    Post

    Solved Matter Control stuck on "Attempting to connect"

    In the audrino IDE, it says board at com 1 is not avalible, and it just loads in mattercontrol
    Post by: SnivyDroid, Nov 14, 2017 in forum: Troubleshooting
  5. SnivyDroid
    Post

    Solved Matter Control stuck on "Attempting to connect"

    Alright, will try later. I did do manual setup and the port i connected to is around the lines of "dev/tty/A__0" (dashes means i dont know.) If...
    Post by: SnivyDroid, Nov 14, 2017 in forum: Troubleshooting
  6. SnivyDroid
    Thread

    Solved Matter Control stuck on "Attempting to connect"

    Ive been trying to get a old robo 3d r1 printer to work, so I got my old linux computer and installed mattercontrol, when I follow the...
    Thread by: SnivyDroid, Nov 14, 2017, 11 replies, in forum: Troubleshooting