1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by techteacher101

  1. techteacher101
    Post

    Printer not printing

    we are up and running! thank you - what is the best thing I can put on the plate to help it set good bases--i was told glue or aquanet (hairspray)
    Post by: techteacher101, Mar 24, 2017 in forum: Troubleshooting
  2. techteacher101
    Post

    Printer not printing

    okay so I tried again set the printer to 210 and continued to move the gear and all of a sudden a bunch of filament came out--i assume filament...
    Post by: techteacher101, Mar 24, 2017 in forum: Troubleshooting
  3. techteacher101
    Post

    Printer not printing

    ha ha! Yea that happened to me on the first batch of filament I loaded--I'm trying to start from scratch now-clean the surface - give it another...
    Post by: techteacher101, Mar 24, 2017 in forum: Troubleshooting
  4. techteacher101
    Post

    Printer not printing

    yes the gear spins- the extruder does not flow out--I've had some weird noises lately as if the motor is not turning on correctly..i do the old...
    Post by: techteacher101, Mar 24, 2017 in forum: Troubleshooting
  5. techteacher101
    Post

    Printer not printing

    by the way I managed to figure out moving the extruder up and down--just don't seem to get it to extrude any filament (yes its at 210 and ready to...
    Post by: techteacher101, Mar 24, 2017 in forum: Troubleshooting
  6. techteacher101
    Thread

    Printer not printing

    Hi everyone, First post I figured I'd try to learn a few things here. My printer had been printing fine right out of the box for two weeks, and...
    Thread by: techteacher101, Mar 24, 2017, 11 replies, in forum: Troubleshooting