1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Terry Wheeler

  1. Terry Wheeler
    Post

    Unanswered Do I need I new one?

    I wish I would of thought of that... I have already ordered one off the site. Oh well lesson learned. Thanks for the reply Sent from my SM-G935T...
    Post by: Terry Wheeler, Mar 21, 2017 in forum: Troubleshooting
  2. Terry Wheeler
    Thread

    Unanswered Do I need I new one?

    Was trying to pull some stuck filament out and the wires pulled off..[IMG] Sent from my SM-G935T using Tapatalk
    Thread by: Terry Wheeler, Mar 21, 2017, 2 replies, in forum: Troubleshooting
  3. Terry Wheeler
    Post

    Unresolved Any ideas why its printing like this

    Thanks I will give this a try
    Post by: Terry Wheeler, Mar 19, 2017 in forum: Troubleshooting
  4. Terry Wheeler
    Post

    Unresolved Any ideas why its printing like this

    I believe it is. I let the printer run the 9 point check before printing, how would I level out the bed in those areas?
    Post by: Terry Wheeler, Mar 19, 2017 in forum: Troubleshooting
  5. Terry Wheeler
    Thread

    Unresolved Any ideas why its printing like this

    I was printing the calibration circle and the printer stop printing but only in certain areas[ATTACH] [ATTACH] rinter seems to stop printing but...
    Thread by: Terry Wheeler, Mar 19, 2017, 4 replies, in forum: Troubleshooting