1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by TylerJ

  1. TylerJ
    Post

    Y Axis Bearing Alternative

    For v6, do you remember what length of socket cap screws?
    Post by: TylerJ, Mar 5, 2016 in forum: Mods and Upgrades
  2. TylerJ
    Post

    Solved Anyone ever seen this?

    I contacted Robo already so I'm waiting to hear back from them. I've had the printer exactly 2 months, I don't know what it wouldn't be covered...
    Post by: TylerJ, Feb 28, 2016 in forum: Troubleshooting
  3. TylerJ
    Post

    Solved Anyone ever seen this?

    I recently got a tiny hairline spot after using PETG the first time (ext 245c / bed 80c). I went on to print many more prints using PETG without a...
    Post by: TylerJ, Feb 28, 2016 in forum: Troubleshooting
  4. TylerJ
    Post

    Unanswered Help! Extra part on bed after print.

    That would be the set screw on the aluminum block just above the nozzle. It holds the two red wires in place, which is the heater
    Post by: TylerJ, Feb 28, 2016 in forum: Troubleshooting
  5. TylerJ
    Post

    PETG suggestions?

    Very nice, thanks to all for the tips. Should this filament be run through an oiler like PLA?
    Post by: TylerJ, Feb 25, 2016 in forum: Printing Filament
  6. TylerJ
    Thread

    PETG suggestions?

    I would like to know print settings and suggestions when using PETG. I'm printing at 245, bed at 50, speed at 50 except for first layer of 8....
    Thread by: TylerJ, Feb 21, 2016, 85 replies, in forum: Printing Filament