1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Will Huff

  1. Will Huff
    Post

    Solved Robo drops power suddenly, repeatedly

    Replaced the fan and reconnected all the wires...everything is working great now. Thanks for all the help!
    Post by: Will Huff, Jul 6, 2018 in forum: Troubleshooting
  2. Will Huff
    Post

    Solved Robo drops power suddenly, repeatedly

    Ok, I'll try to make all these adjustments tonight and run a test.
    Post by: Will Huff, Jul 6, 2018 in forum: Troubleshooting
  3. Will Huff
    Post

    Solved Robo drops power suddenly, repeatedly

    OK. And yes i re attached the grey wire was checking it was on the correct connector, but there were two places open, was making sure this is...
    Post by: Will Huff, Jul 6, 2018 in forum: Troubleshooting
  4. Will Huff
    Post

    Solved Robo drops power suddenly, repeatedly

    Definitely fan dead. I have several replacement 12v fans. I took off the bottom panel and noticed a couple things. I have a few wires not...
    Post by: Will Huff, Jul 6, 2018 in forum: Troubleshooting
  5. Will Huff
    Post

    Solved Robo drops power suddenly, repeatedly

    @mark, there are no error messages. I'm using S3D via USB and once it shuts off the code continues as if its still printing. @Geof, Which fan are...
    Post by: Will Huff, Jul 6, 2018 in forum: Troubleshooting
  6. Will Huff
    Thread

    Solved Robo drops power suddenly, repeatedly

    I have a big problem. After thousands of hours of printing and no issues, I have this new issue, where the whole thing powers off (as seen in this...
    Thread by: Will Huff, Jul 5, 2018, 12 replies, in forum: Troubleshooting