1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Xeovan

  1. Xeovan
    Post

    Unanswered How can i Use CURA 2.5 for my Robo3D R1 + lead Screw Upgrade?

    Hey, I am also having issues with Cura 2.5 on my robo R1+. My issues is that once the printer warms up and starts to print it prints 2 inches off...
    Post by: Xeovan, Dec 29, 2017 in forum: General Questions
  2. Xeovan
    Profile Post

    Hey Mike, I'm having trouble using Cura 2.5 with my R1+ I cant seem to get the start Gcode right...

    Hey Mike, I'm having trouble using Cura 2.5 with my R1+ I cant seem to get the start Gcode right the default gcode for the R1+ from Cura 2.5...
    Profile post by Xeovan for Mike Kelly, Dec 29, 2017
  3. Xeovan
    Post

    Cura 2.5

    Ive had the same issue where the standard Gcode that comes with Cura 2.5 for the Robo R1+ runs fine but then when it prints it prints about two...
    Post by: Xeovan, Dec 29, 2017 in forum: Software
  4. Xeovan
    Thread

    Pls Halp Cura 2.3 Gcode For R1 Plus

    Hey, I usually print with Cura 15.04.6 and have tried switching to Cura 2.3 for Robo. I selected the available preset for an R1 Plus, but when I...
    Thread by: Xeovan, May 13, 2017, 0 replies, in forum: Software