1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Problem printing with octoprint and XXLCD

Discussion in 'Troubleshooting' started by Domenic, Jan 27, 2017.

Thread Status:
Not open for further replies.
  1. Domenic

    Domenic Member

    Joined:
    Dec 1, 2016
    Messages:
    60
    Likes Received:
    3
    This just happened out of the blue. I was messing around with the startup gcode and after every print this happens. It still prints fine. I am using robo version of cura 2.3 and am sending the model straight from cura to octoprint.
     

    Attached Files:

    #1 Domenic, Jan 27, 2017
  2. Spidematt

    Spidematt Member

    Joined:
    Nov 24, 2016
    Messages:
    63
    Likes Received:
    14
    That randomly happens to me as well the lcd controller doesnt seem to cooperate with octoprint it has to do with the usb. Just slide a memory card in it and take it out and it should go back to normal at least it does for me anyhow
     
    #2 Spidematt, Jan 27, 2017
  3. Domenic

    Domenic Member

    Joined:
    Dec 1, 2016
    Messages:
    60
    Likes Received:
    3
    ok thanks
     
    #3 Domenic, Jan 27, 2017
  4. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Or power off you Robo and unplug the USB cable, plug it all back in and turn it on and your good to go. (This procedure is just rebooting your printer)
     
    #4 WheresWaldo, Jan 28, 2017
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    The power switch does not reboot the electronics in the printer if you keep the USB cable plugged in :)
     
    #5 mark tomlinson, Jan 28, 2017
Thread Status:
Not open for further replies.

Share This Page