1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partially Solved Connected to Arduino, but printer not responding to commands

Discussion in 'Troubleshooting' started by Sir_Kibble, Jun 3, 2017.

Page 2 of 2
  1. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Are you certain you have the thermistors hooked up correctly ? Typically if the bed temp keeps climbing its because the thermistors are hooked up funny. If you mishook your end stops you'll also have some issues (bad ones)
     
    #21 Geof, Jul 14, 2017
    mark tomlinson likes this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Once you get the machine working I can point you to diagnostics you can do to see if a RAMPS or Arduino is working correctly and you can weed out what is still good.
     
    #22 mark tomlinson, Jul 14, 2017
  3. Sir_Kibble

    Sir_Kibble New Member

    Joined:
    Jan 18, 2017
    Messages:
    10
    Likes Received:
    1
    I'll grab another kit and return the other board. It may be a while before I can post back with the results, as I'll be leaving town for a couple months. Thanks again for all your help!
     
    #23 Sir_Kibble, Jul 19, 2017
    Geof likes this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    No worries. Let us know.

    Sent from my SAMSUNG-SM-G930A using Tapatalk
     
    #24 mark tomlinson, Jul 19, 2017
    Geof likes this.
Page 2 of 2

Share This Page