1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved new factory robo r1+ramps board, after market stepper motors

Discussion in 'Troubleshooting' started by eric tobin, Feb 8, 2018.

  1. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    I had to get a ramps board, picked up two z axis steeper motors. the wires for the original motors does not match the new stepper wiring what should I do? first pic is stock wire second won is new wire IMG_0199 (2).JPG IMG_0200 (2).JPG
     
    #1 eric tobin, Feb 8, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #2 mark tomlinson, Feb 8, 2018
    Geof likes this.
  3. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    I got the motors from amazon. description
    "iverntech NEMA stepper motor with intergrated 310 mm T8 lead screwfor reprap prusa z axis or cnc machine"
    the new steppers are able to accept a 6 pin connector
     
    #3 eric tobin, Feb 8, 2018
  4. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    got it figured out, just had to look at the wiring diagram. hey what can I say I am still a rookie. thanks for your help I do appreciate it
     
    #4 eric tobin, Feb 8, 2018
    Geof likes this.

Share This Page