1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z Offset Issues

Discussion in 'Troubleshooting' started by JuniorGamingTime, Jun 6, 2018.

Thread Status:
Not open for further replies.
  1. JuniorGamingTime

    JuniorGamingTime New Member

    Joined:
    Jun 3, 2018
    Messages:
    6
    Likes Received:
    0
    **Just got my printer**
    So like the title says im trying to set the Z offset
    i use the code M565 Z-1.1 like in the "Novice Expert" Youtube video
    and when i do G28 or G29 the head just keeps touching the bed like if it didn't take the M565 command
     
    #1 JuniorGamingTime, Jun 6, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    What is your startup GCode block. Paste it in here. Probably a simple fix

    (also, maybe mention which printer it is)
     
    #2 mark tomlinson, Jun 6, 2018
    Last edited: Jun 6, 2018
    Geof likes this.
  3. JuniorGamingTime

    JuniorGamingTime New Member

    Joined:
    Jun 3, 2018
    Messages:
    6
    Likes Received:
    0
    Yeah i have the R1 + and i think i have it figured out:
    G1 E-0.4
    G28;
    M565 Z-1.2
    G29;


    But i do have one issues idk if its just me but does the extruder always a bit loud when retracting?
     
    #3 JuniorGamingTime, Jun 7, 2018
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    As long as it is after the last G28 and before the G29 you are good.
     
    #4 mark tomlinson, Jun 7, 2018
Thread Status:
Not open for further replies.

Share This Page