1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Part fell off printer , no schematic to where it goes.

Discussion in 'Troubleshooting' started by Maximumcaraudio, Oct 7, 2015.

  1. Maximumcaraudio

    Maximumcaraudio New Member

    Joined:
    Oct 7, 2015
    Messages:
    3
    Likes Received:
    0
    Ive tried to search for a assembly schematic but no luck there. I can best describe the part as a letter F that is 1 inch x 1 inch. Then at the bottom of the letter F it has a nut and screw that go into it, I found these laying under the bed during a print which the printer still prints fine. (NOTE: This is an R1 + ) About 3 weeks old. Any help on this matter would be very much appreciated.
     
    #1 Maximumcaraudio, Oct 7, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Pictures please.
     
    #2 mark tomlinson, Oct 7, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Most of us don't have an R1+ but it should be something we can sort out if we see it.
     
    #3 mark tomlinson, Oct 7, 2015
  4. Maximumcaraudio

    Maximumcaraudio New Member

    Joined:
    Oct 7, 2015
    Messages:
    3
    Likes Received:
    0
    20151007_120919.jpg
     
    #4 Maximumcaraudio, Oct 7, 2015
  5. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    that holds the ribbon cable on the back of the Y axis. It's not critical
     
    #5 Mike Kelly, Oct 7, 2015
  6. Maximumcaraudio

    Maximumcaraudio New Member

    Joined:
    Oct 7, 2015
    Messages:
    3
    Likes Received:
    0
    Got it fixed, Thank you for pointing out its location. LIttle Thread lock wouldn't hurt during manufactering.
     
    #6 Maximumcaraudio, Oct 7, 2015
  7. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Since Day 1... this has been needed :)
     
    #7 mark tomlinson, Oct 7, 2015
  8. jbigler1986

    jbigler1986 Active Member

    Joined:
    Feb 13, 2015
    Messages:
    534
    Likes Received:
    128
    I just love the Robo quality control. Top notch. They need to start sending 2 y belt clips as spares with the printer. Both of mine were broke on the one we got at work. Replaced one with their spare and super glued the other so I could print a spare. They are funny
     
    #8 jbigler1986, Oct 7, 2015

Share This Page