1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Issues with vertical circles

Discussion in 'Troubleshooting' started by Corey Brumfield, Feb 2, 2016.

Page 2 of 2
  1. Corey Brumfield

    Corey Brumfield New Member

    Joined:
    Apr 16, 2015
    Messages:
    23
    Likes Received:
    0
    Well I uploaded the firmware and I am printing another cube, fingers crossed
     
    #21 Corey Brumfield, Feb 3, 2016
  2. Corey Brumfield

    Corey Brumfield New Member

    Joined:
    Apr 16, 2015
    Messages:
    23
    Likes Received:
    0
    FIXED IT SPOT ON 20MM
     
    #22 Corey Brumfield, Feb 3, 2016
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    This is only true for certain batches of the R1+.
    Congrats
     
    #23 Mike Kelly, Feb 3, 2016
  4. Corey Brumfield

    Corey Brumfield New Member

    Joined:
    Apr 16, 2015
    Messages:
    23
    Likes Received:
    0
    Okay the height is fixed, but I still can not get pins to fit, or nuts to screw on bolts. lol
     
    #24 Corey Brumfield, Feb 3, 2016
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Well, here is something to consider...
    all of the plastic deforms a bit when you print it. Some swells a little some shrinks a little.
    You have to account for that when you do the model.

    We usually do a test print with the holes/fittings and the plastic we are going to use and then see what it does and adapt the model.
     
    #25 mark tomlinson, Feb 3, 2016
Page 2 of 2

Share This Page