1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

E3d volcano

Discussion in 'General Questions' started by 2brosmanufacturing, Feb 13, 2016.

  1. 2brosmanufacturing

    2brosmanufacturing New Member

    Joined:
    Dec 26, 2015
    Messages:
    11
    Likes Received:
    1
    Went and looked at another robo to sell to my brother to replace is prusa i3. Came with then e3d v6 and xxl along with a spare v6, and the volcano. Well i kept the volcano as i already have the e3d in mine. Whats everyones thoughts on the volcano?
     
    #1 2brosmanufacturing, Feb 13, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #2 mark tomlinson, Feb 14, 2016
  3. 2brosmanufacturing

    2brosmanufacturing New Member

    Joined:
    Dec 26, 2015
    Messages:
    11
    Likes Received:
    1
    So for doing larger parts it would be good but probably not for alot of the smaller parts.
     
    #3 2brosmanufacturing, Feb 14, 2016
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    I disagree.
    I think it is fine for anything of reasonable size. More so now that they even have a 0.4 nozzle for it.
    If you are printing something at 50 microns... OK, don't use a Volcano, otherwise.. it is fine :)
     
    #4 mark tomlinson, Feb 14, 2016
    Geof likes this.

Share This Page