Solved Y Axis uneven/unlevel seating

There appears to be another problem. My Y axis (rods?) is slightly unlevel to the point where the bed thins out layers/doesn't print them or layers are too high. What I mean is ie, I print a single line hitting all four corners, it'll print in the middle fine but any area on the left side ends up practically hitting the hotend and it doesn't print at all due to not enough space. While on the area on the right will be too high and filament won't be stick to the bed. This means I can't print things that are too wide or long or my filament will get jammed. I believe the source of the problem is the huge black part that the Y rod seats rest on. My right side Y rod seat is also cracked but that doesn't seem like it affects the bed. The right side is warped/caved in so I might need to replace it. I'll post pics soon.
--
low prints too low and easily comes off the bed, if it even sticks, unusable
high is to the point where the layer will be squashed flat against the bed, barely usable
too hi is where it just ends up with the hotend skidding across the bed, unusable
hi is just like high but not to the point where it's squashed flat, just a bit, usable
______________
|hi------------too hi|
|ok-----------too hi|
|ok-----------too hi|
|low-----------high|
|low--------------hi|
¯¯¯¯¯¯¯¯¯¯¯¯¯¯

 

Do a paper leveling of the X axis and post your G29 response codes from terminal

 

How do I paper level the X axis?

 

Sticking a piece of paper until the nozzle as a feeler and adjusting the Z rods

 

Hi guys I have this problem too i'd appreciate if you would be a little bit more clear on what your asking me too do

 

After messing about with it, I figured out exactly what was wrong. I was right when I said that there was something loose under the bed. One of the pillow blocks is cracked and inside of it, whatever that's holds the rail is broken and causes one side of my bed to be jiggle, leading to it messing up.

 

I got it second hand so I'm out of warranty. I'll print out the alt one when I can.

 

Could I print this out as a straight replacement or would I have to buy some parts?