1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Abs trouble

Discussion in 'Troubleshooting' started by gunsmoke132, May 22, 2016.

  1. gunsmoke132

    gunsmoke132 Member

    Joined:
    May 13, 2016
    Messages:
    183
    Likes Received:
    14
    ive gone through a few prints fine but for some reason it keeps bunching up on the outside after it makes an "outline shape' IT MIGHT OF BEEN THE MODEL. checking now
     
    #1 gunsmoke132, May 22, 2016
    Last edited: May 22, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    A picture would be better.
     
    #2 mark tomlinson, May 22, 2016
  3. gunsmoke132

    gunsmoke132 Member

    Joined:
    May 13, 2016
    Messages:
    183
    Likes Received:
    14
    ok will do
     
    #3 gunsmoke132, May 22, 2016
  4. gunsmoke132

    gunsmoke132 Member

    Joined:
    May 13, 2016
    Messages:
    183
    Likes Received:
    14
    simple fix. some how the offset got set too high
     
    #4 gunsmoke132, May 22, 2016
    Geof and mark tomlinson like this.
  5. gunsmoke132

    gunsmoke132 Member

    Joined:
    May 13, 2016
    Messages:
    183
    Likes Received:
    14
    i think that was it i cleaned the bed real nice re adheased it and put the offset to 1
     
    #5 gunsmoke132, May 31, 2016

Share This Page