1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Request: Radial part cooling fan for E3Dv6 and stock carriage w/o losing clearance

Discussion in 'Mods and Upgrades' started by nonmindo, Jul 11, 2016.

  1. nonmindo

    nonmindo New Member

    Joined:
    Jul 29, 2015
    Messages:
    12
    Likes Received:
    1
    I found this on thingiverse, but it looses some build volume because it is too bulky, I was wondering if anyone could make something similar or knows of one already.

    I'd like it to work with the stock carriage if possible

    http://www.thingiverse.com/thing:409483
     
    #1 nonmindo, Jul 11, 2016
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    You could use that one with a better fan.The fans from Robo are not moving much air.
    Get a Noctua fan and it will move enough air. There are other brands.
     
    #2 mark tomlinson, Jul 12, 2016
  3. nonmindo

    nonmindo New Member

    Joined:
    Jul 29, 2015
    Messages:
    12
    Likes Received:
    1
    I would but as it's designed he mentioned it looses some print volume because it hits the bottom edge of the RoBo cover when it goes too far up, ID rather not lose any print area :-/, I think I actually did buy a noctua already I'm running a single one of NoviceExpert's tool-less coolers, but due to how I mounted the hot end there isn't enough clearance for the front duct to mount, it hits the hot end heat block and I'm the terrible when it comes to modifying or making any kind of intricate models
     
    #3 nonmindo, Jul 12, 2016

Share This Page