1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

The Printer

Discuss what you're printing, what software you're using, projects you're working on, mods and upgrades you implemented, and what filaments you're using below

  1. Show and Tell
    New

    Post about your printer, your settings, post pictures of when you get the printer.
    Latest: Amazon Sain Smart Lead Screws by ssshake, Sep 8, 2020
    219
    Discussions
    3,273
    Messages
    RSS

  2. Community Recommendations
    New

    Here the community can post and only post pre-vetted and community approved recommendations for improvements or changes to the R1+ 3d Printer.
    Latest: Printing too large by Geof, Jan 30, 2019
    3
    Discussions
    16
    Messages
    RSS

  3. Software
    New

    3D Printing Software
    Latest: [Help] config.g for Kickstarter Robo3D by Rod Smith, Nov 19, 2020
    273
    Discussions
    2,979
    Messages
    RSS

  4. Projects
    New

    Share your projects, pictures, ideas, and prints!
    Latest: Bed replacement on R1 beta by mark tomlinson, Feb 10, 2020
    200
    Discussions
    2,899
    Messages
    RSS

  5. Printing Filament
    New

    Have a question on Filament? What filament should you use?
    Latest: Help with ColorFabb XT by mark tomlinson, Oct 11, 2020
    276
    Discussions
    3,296
    Messages
    RSS

  6. Mods and Upgrades
    New

    Robo3D Mods and Upgrades
    Latest: When replacing the lead screws do you have to get a new motor? by mark tomlinson, Oct 15, 2020
    651
    Discussions
    15,197
    Messages
    RSS