1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Stud Thermistor for R1+

Discussion in 'Troubleshooting' started by Dennis Pyles, Dec 12, 2016.

  1. Dennis Pyles

    Dennis Pyles New Member

    Joined:
    May 27, 2016
    Messages:
    12
    Likes Received:
    0
    I have the R1+ and I need a new stud thermistor. The store on here has none at all. The ones I see on printedsolid are all screw in thermistor. Where can I get the stud thermistor that was OEM for the R1+?
     
    #1 Dennis Pyles, Dec 12, 2016
  2. Rigmarol

    Rigmarol Well-Known Member

    Joined:
    May 14, 2016
    Messages:
    544
    Likes Received:
    280
    I got mine by calling Robo. They had them to me in about a week or so.
     
    #2 Rigmarol, Dec 12, 2016
  3. Dennis Pyles

    Dennis Pyles New Member

    Joined:
    May 27, 2016
    Messages:
    12
    Likes Received:
    0
    I've emailed but no response yet. Maybe I should call. But I need them quickly
     
    #3 Dennis Pyles, Dec 12, 2016
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    There never was a metalstud thermistor that was OEM.
    There is the can-style thermistor that Robo switched to.

    However I am not sure who (other than Robo) carries them.
     
    #4 mark tomlinson, Dec 12, 2016
  5. Dennis Pyles

    Dennis Pyles New Member

    Joined:
    May 27, 2016
    Messages:
    12
    Likes Received:
    0
    Do I need to call to get them? I didnt see any thermistors at the store at all
     
    #5 Dennis Pyles, Dec 12, 2016
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Yes you do. Fair warning, if they are not listed then they *may* be out of stock.
    This is one reason many people swap away from the stock hexagon (just saying) since parts are not readily available.
     
    #6 mark tomlinson, Dec 12, 2016
  7. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    The thermistors were never a listed part, just the whole hexagon. Calling them is your best bet. Plan at least 1 week down. If you need something printed hit up a print service or myself and a few others would likely help out
     
    #7 Geof, Dec 12, 2016
    Toro1966 and mark tomlinson like this.

Share This Page