1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Iamkar33m
    Post

    PID tuning and Marlin

    What a pain! So you have to re-PID tune after you run a z-offset?
    Post by: Iamkar33m, Nov 26, 2017 in forum: General Questions
  2. Iamkar33m
    Post

    Light...

    Just upgraded my Robo R2 as well. I can't believe it didn't come this way from the manufacturer. I opted to run the wiring/electronics separate...
    Post by: Iamkar33m, Nov 25, 2017 in forum: Mods and Upgrades
  3. Iamkar33m
    Thread

    Simplify 3d + OctoPrint

    Hey guys, I'm new here to 3D printing with Simplify3d and Octoprint. I've been using Cura w/ my previous printer (Monoprice Select Mini v2), and...
    Thread by: Iamkar33m, Nov 10, 2017, 7 replies, in forum: Software
  4. Iamkar33m
    Thread

    Greetings from sunny California

    Hey All, My name's Kareem, I just picked up my Robo 3d R2 last weekend and I'm trying to learn how to maximize it's capabilities! Hope to see...
    Thread by: Iamkar33m, Nov 10, 2017, 3 replies, in forum: United States of America
Showing results 1 to 4 of 4
Search Again