1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Hellsbells
    Post

    Buildtak Flexplate or PEI

    Nope no leveling issues at all. Sent from my iPad using Tapatalk
    Post by: Hellsbells, May 14, 2018 in forum: Mods and Upgrades
  2. Hellsbells
    Post

    Used R2 for Sale

    Kind of what I was thinking. The Robo R2 is a piece of unreliable junk. I will probably just keep it as a backup or for small easy prints.
    Post by: Hellsbells, Apr 11, 2018 in forum: Off Topic
  3. Hellsbells
    Thread

    Buildtak Flexplate or PEI

    ROBO is replacing my R2 failing V1 heat bed with the V2. I am looking at either using the Buildtak Flexplate or PEI for better adhesion and...
    Thread by: Hellsbells, Apr 4, 2018, 7 replies, in forum: Mods and Upgrades
  4. Hellsbells
    Post

    Unanswered Extrudes but doesn't print

    I have tried .2 through .5mm z offsets but still no luck. Any thoughts on which new slicer I should try?
    Post by: Hellsbells, Dec 26, 2016 in forum: Troubleshooting
  5. Hellsbells
    Thread

    Unanswered Extrudes but doesn't print

    I installed a E3D V6 hot end. It will extruded material when I click on E+ in MatterControl but it won't print. It is doing the self leveling...
    Thread by: Hellsbells, Dec 25, 2016, 4 replies, in forum: Troubleshooting
Showing results 1 to 5 of 5
Search Again