1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Vader1974
    Post

    E3D v6 Information, Installation Guides, and Review

    Thanks. Could that wiggle in my hotend be the cause for random x axis shift?
    Post by: Vader1974, Feb 23, 2016 in forum: Mods and Upgrades
  2. Vader1974
    Post

    E3D v6 Information, Installation Guides, and Review

    Can an R1 be fitted with a quick change plate to secure the extruder?
    Post by: Vader1974, Feb 23, 2016 in forum: Mods and Upgrades
  3. Vader1974
    Post

    E3D v6 Information, Installation Guides, and Review

    I have a Robo3d R1. I recently upgraded to the e3d v6 lite. My e3d is incredibly loose the the carriage. I am assuming that this is the reason...
    Post by: Vader1974, Feb 23, 2016 in forum: Mods and Upgrades
  4. Vader1974
    Post

    Unresolved Uneven Vertical Surfaces (Cylinder)

    Ok, so I need to change the following line from: define DEFAULT_MAX_ACCELERATION {9000,9000,100,10000} // X, Y, Z, E maximum start speed for...
    Post by: Vader1974, Feb 6, 2016 in forum: Troubleshooting
  5. Vader1974
    Thread

    Unresolved Uneven Vertical Surfaces (Cylinder)

    I have an Robo3d R1. Printing in PLA (200 degrees, 60 degree bed). Simplify3d. .2mm layer I did not have this problem prior to recently...
    Thread by: Vader1974, Feb 5, 2016, 5 replies, in forum: Troubleshooting
Showing results 1 to 5 of 5
Search Again