1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Sliced Br3D
    Thread

    why a part cooling fan?

    Maybe a noob type question, but in my experience, it seems like it does more harm than good with PLA. Overhangs seem to curl up more when I run...
    Thread by: Sliced Br3D, Oct 12, 2017, 2 replies, in forum: General Questions
  2. Sliced Br3D
    Profile Post

    Now offering 3D printing services including 3D design

    Now offering 3D printing services including 3D design
    Status update by Sliced Br3D, Apr 1, 2017
  3. Sliced Br3D
    Post

    Changing Filament Color mid-print

    In MC 1.6 (Windows) this option is under General/Single Print/Layer(s) to pause - you can pause on multiple layers by separating the numbers with...
    Post by: Sliced Br3D, Jan 21, 2017 in forum: General Questions
  4. Sliced Br3D
    Post

    E3D v6 Information, Installation Guides, and Review

    OK, Thanks :) I'll take your advice and see if my printer likes v3, and if not I figured out which v2 to modify and use if I need to revert to it.
    Post by: Sliced Br3D, Jan 17, 2017 in forum: Mods and Upgrades
  5. Sliced Br3D
    Post

    E3D v6 Information, Installation Guides, and Review

    I did know it's an R1 - just wasn't sure which r1v2 to use in the OP. Those have been updated to the most current version, right? And I want the...
    Post by: Sliced Br3D, Jan 17, 2017 in forum: Mods and Upgrades
  6. Sliced Br3D
    Post

    E3D v6 Information, Installation Guides, and Review

    OK - I've read thru ALL 38 PAGES of this thread and I'm doin' this thing... my questions start at the beginning - identifying my printer. I bought...
    Post by: Sliced Br3D, Jan 17, 2017 in forum: Mods and Upgrades
  7. Sliced Br3D
    Post

    E3D v6 Information, Installation Guides, and Review

    LOL! Reminds me of my dad saying how you could fix a Model-T with bailing wire and bubblegum! My my, how technology has changed (yet stays the...
    Post by: Sliced Br3D, Jan 16, 2017 in forum: Mods and Upgrades
  8. Sliced Br3D
    Post

    3D Printer settings - MatterControl

    I just use the default settings - the only thing I had to change was the Z offset to .07, and print quality to high.
    Post by: Sliced Br3D, Dec 6, 2016 in forum: General Questions
Showing results 1 to 8 of 8
Search Again