1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. mjones0216
    Post

    PID auto tune with fans on?

    Thanks for the help guys! After updating the firmware and still having temp drops after 5-10 layers, I did some poking around and found that it my...
    Post by: mjones0216, Oct 26, 2016 in forum: Software
  2. mjones0216
    Post

    PID auto tune with fans on?

    Ah gotcha, I'll have to change the thermistor type. What do I change it to? I haven't done too much with firmware besides tweaking auto level...
    Post by: mjones0216, Oct 24, 2016 in forum: Software
  3. mjones0216
    Thread

    PID auto tune with fans on?

    I've upgraded to an E3DV6 extruder and installed the included thermistor. I'm attempting to do a PID auto tune because I keep getting the temp...
    Thread by: mjones0216, Oct 24, 2016, 6 replies, in forum: Software
  4. mjones0216
    Post

    .2mm nozzle and simplify3d. dumb question

    Thanks guys! Simplify3d will control the flow rate right? I won't have to compensate for the smaller nozzle? Do you have any other tips for...
    Post by: mjones0216, Sep 16, 2016 in forum: Mods and Upgrades
  5. mjones0216
    Thread

    .2mm nozzle and simplify3d. dumb question

    So as the title states, this is probably a dumb question. I want to use a .2mm nozzle for small parts. Do I have to change any other parameters...
    Thread by: mjones0216, Sep 15, 2016, 7 replies, in forum: Mods and Upgrades
  6. mjones0216
    Post

    Unanswered LED's flickering during use. Power Supply issue?

    Mine flicker a little bit while heating up, but I haven't had any negetive issues. I originally had it in the dining room and moved it so we could...
    Post by: mjones0216, Apr 12, 2016 in forum: Troubleshooting
  7. mjones0216
    Post

    Solved RepRap discount full graphic LCD help

    Thanks guys, finally got it!
    Post by: mjones0216, Feb 23, 2016 in forum: Troubleshooting
  8. mjones0216
    Thread

    Solved RepRap discount full graphic LCD help

    I'm trying to update the firmware on my R1+ to use the discount full graphic LCD. I cant get it to verify/compile. I keep getting...
    Thread by: mjones0216, Feb 20, 2016, 8 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again