1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. WindDrake
    Post

    Solved Strangely indented perimiter issues.

    Weird thing is, I've had great luck with Mattercontrol. Printed the entire Open R/C F1 with it, tons of stuff. Might be able to call this one...
    Post by: WindDrake, Jan 25, 2017 in forum: Troubleshooting
  2. WindDrake
    Post

    Solved Strangely indented perimiter issues.

    Might be on to something with the slice engine. Matterslice is crapping itself on these models, while they turn out mostly OK with Slic3r as the...
    Post by: WindDrake, Jan 25, 2017 in forum: Troubleshooting
  3. WindDrake
    Post

    Solved Strangely indented perimiter issues.

    Here's an XY Resonance Test object. First up is the proper seam. [img] Next up is the weird part. [img] This is supposed to be this. [img]...
    Post by: WindDrake, Jan 25, 2017 in forum: Troubleshooting
  4. WindDrake
    Thread

    Solved Strangely indented perimiter issues.

    Easiest way to show this is pictures, so here's a Benchy and an accuracy test object. [IMG] [IMG] As you can see, at the starting angle point,...
    Thread by: WindDrake, Jan 24, 2017, 11 replies, in forum: Troubleshooting
  5. WindDrake
    Post

    Solved Y-Axis Issues

    @WheresWaldo - No worries. I've dialed my firmware in for the mechanics of my specific printer now. I should have known better than to trust the...
    Post by: WindDrake, Dec 25, 2016 in forum: Troubleshooting
  6. WindDrake
    Thread

    Solved Y-Axis Issues

    Had something strange happen today when printing a large object on my R1+. It is running a Smart LCD Controller, as well as Marlin RC8...
    Thread by: WindDrake, Dec 25, 2016, 3 replies, in forum: Troubleshooting
  7. WindDrake
    Post

    Solved PETG zits.

    I ran 28 parts in 3DXStat PETG yesterday, all zit-free. Bone stock R1+. In Mattercontrol, I reduced the retraction rate to 25mm/sec, and ensured...
    Post by: WindDrake, Dec 24, 2016 in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again