1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Sarg1
    Post

    Solved Extruder wiring

    Thanks for trying. After sleeping on it, I finally figured it out. I did swap some wires around on both ends. Now it is humming along just fine.
    Post by: Sarg1, Sep 3, 2017 in forum: Troubleshooting
  2. Sarg1
    Post

    Solved Extruder wiring

    Here is the harness. One end plugs into the extruder motor the other connects to the arduino board. I need to know if the wires are in the correct...
    Post by: Sarg1, Sep 2, 2017 in forum: Troubleshooting
  3. Sarg1
    Thread

    Solved Extruder wiring

    Long story short. I had ordered new wiring harness off of Amazon. My problem is that I no longer have the original to look at to see if the wires...
    Thread by: Sarg1, Sep 2, 2017, 4 replies, in forum: Troubleshooting
  4. Sarg1
    Post

    Community Favorite E3D v6 Information and Installation Guide

    I have a quick question. How do you change these settings in the matter control tablet?
    Post by: Sarg1, Mar 5, 2017 in forum: Mods and Upgrades
  5. Sarg1
    Post

    E3D v6 Information, Installation Guides, and Review

    Just changed out my original print head for the E3D v6 on my ROBO3D plus. Updated the firmware. Tried to print a few things. The result was that...
    Post by: Sarg1, Jan 29, 2017 in forum: Mods and Upgrades
Showing results 1 to 5 of 5
Search Again