1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. invinciblegod
    Post

    Unresolved Abs getting stuck

    I can manually feed with the gears. It works with PLA and sometimes it works with ABS but not usually. The tension should be fine as I can...
    Post by: invinciblegod, May 13, 2016 in forum: Troubleshooting
  2. invinciblegod
    Thread

    Unresolved Abs getting stuck

    Printing with PLA is fine however, 9/10 of the time when I print with ABS the filament would stop extruding on the first layer. It's not actually...
    Thread by: invinciblegod, May 13, 2016, 11 replies, in forum: Troubleshooting
  3. invinciblegod
    Thread

    Unanswered How do I change print location?

    After checking under the bed, I noticed that my robo3d has not been printing entirely on the heated area. How do I change the Y offsets of the bed...
    Thread by: invinciblegod, Apr 9, 2016, 1 replies, in forum: Troubleshooting
  4. invinciblegod
    Thread

    Solved What is the optimal distance between the bed and nozzle?

    The first time I tried with my new hotend the nozzle was pushing along the bed causing extrusion problems and jamming. What distance is good?
    Thread by: invinciblegod, Apr 9, 2016, 1 replies, in forum: Troubleshooting
  5. invinciblegod
    Thread

    Unanswered Robo 3D when doing G29 moves down by 20mm in the Y axis causing it to hit the limit

    So each time I print it does G29 and moves down the bed. However, because it is offset by 20mm or so, on the final 3 points the bed tries to move...
    Thread by: invinciblegod, Apr 9, 2016, 1 replies, in forum: Troubleshooting
  6. invinciblegod
    Post

    Answered Print location is different from what is shown in mattercontrol

    So I assume that means the square does not indicate the heated portion. Is the whole bed heated?
    Post by: invinciblegod, Apr 5, 2016 in forum: Troubleshooting
  7. invinciblegod
    Thread

    Answered Print location is different from what is shown in mattercontrol

    I don't know if this is a problem but the print location is different than what is shown on mattercontrol. As can be seen from the file, it is...
    Thread by: invinciblegod, Apr 5, 2016, 9 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again