1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. nol b
    Thread

    Help with ColorFabb XT

    in the below picture, i have my XT print on the left and my PLA print on the right. the XT was printed using around half the speed of PLA. can...
    Thread by: nol b, May 29, 2020, 21 replies, in forum: Printing Filament
  2. nol b
    Thread

    Marlin 2.0.X Autolevel

    today i upgraded the firmware on my modified R1 to Marlin 2.0.5.3. it seems to be working well so far. i am uncertain on one thing with the...
    Thread by: nol b, May 15, 2020, 9 replies, in forum: Mods and Upgrades
  3. nol b
    Thread

    Solved Autolevel Z offset

    My z offset doesn't seem to be working. I switched over to Cura (in an attempt to troubleshoot some other stuff). I am guessing that something in...
    Thread by: nol b, Apr 28, 2020, 6 replies, in forum: Troubleshooting
  4. nol b
    Thread

    Unresolved E3Dv6 Strings

    I'm getting a lot of stringing in my prints with my E3Dv6. It has that little silicone sock (see link below) over it but I don't know if that's...
    Thread by: nol b, Apr 1, 2017, 1 replies, in forum: Troubleshooting
  5. nol b
    Thread

    E3Dv6 Cooling Fan

    The E3dv6 guide says to plug the cooling fan into the same place that the RAMPS board fan is plugged into. Is there another place to plug the...
    Thread by: nol b, Mar 26, 2017, 7 replies, in forum: Mods and Upgrades
  6. nol b
    Thread

    Answered Print Bed Stopped Heating

    My print bed stopped heating. Does that mean I need to replace the 5 amp fuse?...
    Thread by: nol b, Feb 12, 2016, 20 replies, in forum: Troubleshooting
  7. nol b
    Thread

    Unresolved ColorFabb XT Settings

    I am having trouble calibrating my printer for ColorFabb XT. Right now I am printing at 245deg nozzle and 70deg bed. The issues I'm encountering...
    Thread by: nol b, Jan 31, 2016, 3 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again