1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Staube3
    Post

    Solved ABS Printing issues

    I was able to figure things out. I believe that I must have opened the brass nozzle just a touch to much when cleaning last. I replaced the nozzle...
    Post by: Staube3, Nov 1, 2019 in forum: Troubleshooting
  2. Staube3
    Post

    Solved ABS Printing issues

    That makes sense. I’m going to check that out. I’ll post my findings. Thanks for the suggestions. Sent from my iPhone using Tapatalk
    Post by: Staube3, Oct 31, 2019 in forum: Troubleshooting
  3. Staube3
    Post

    Solved ABS Printing issues

    Also it extrudes manually without issue. The filament looks good and rafting seems to print without issues. It appears that the problem occurs on...
    Post by: Staube3, Oct 31, 2019 in forum: Troubleshooting
  4. Staube3
    Post

    Solved ABS Printing issues

    It was spinning, however, the fan shroud is starting to look dirty and worn. Sent from my iPhone using Tapatalk
    Post by: Staube3, Oct 31, 2019 in forum: Troubleshooting
  5. Staube3
    Thread

    Solved ABS Printing issues

    I am having difficulties printing a design I have used a dozen time in the past. I don't know what the issue could be that is causing this but I...
    Thread by: Staube3, Oct 30, 2019, 7 replies, in forum: Troubleshooting
  6. Staube3
    Post

    MINTEMP Triggered

    I appreciate the input and advice. I went out on a limb and purchased a new RAMPS board from Amazon. Wired it all up and when I powered it back...
    Post by: Staube3, Nov 29, 2017 in forum: Troubleshooting
  7. Staube3
    Thread

    MINTEMP Triggered

    I have been troubleshooting issues that have seemed to lead me down the endless rabbit hole lately with Max and Min temp errors on my Robo 3d R1+....
    Thread by: Staube3, Nov 25, 2017, 2 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again