1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Alex A
    Post

    Unanswered LCD controller from printed solid

    The pin connector was loose inside The pin connector was loose on the inside
    Post by: Alex A, Jan 11, 2017 in forum: Troubleshooting
  2. Alex A
    Post

    Unanswered LCD controller from printed solid

    The pin connector was loose inside
    Post by: Alex A, Jan 11, 2017 in forum: Troubleshooting
  3. Alex A
    Post

    Unanswered LCD controller from printed solid

    The plug was loose inside
    Post by: Alex A, Jan 11, 2017 in forum: Troubleshooting
  4. Alex A
    Post

    Unanswered LCD controller from printed solid

    Robo R1 plus got it last April I downloaded it from the matter control window from the application on my desktop
    Post by: Alex A, Jan 10, 2017 in forum: Troubleshooting
  5. Alex A
    Post

    Unanswered LCD controller from printed solid

    I'll check the connections underneath maybe something moved or came loose when I transported it
    Post by: Alex A, Jan 10, 2017 in forum: Troubleshooting
  6. Alex A
    Post

    Unanswered LCD controller from printed solid

    1.6.1.7967
    Post by: Alex A, Jan 10, 2017 in forum: Troubleshooting
  7. Alex A
    Thread

    Unanswered LCD controller from printed solid

    I have the XXL LCD controller and printed solid, it worked fine for a while but I moved and didn't use my printer for a bit. When I restarted it...
    Thread by: Alex A, Jan 10, 2017, 12 replies, in forum: Troubleshooting
  8. Alex A
    Thread

    Solved EEProm/rediculously slow extrusion

    I have a couple problems, there are a few versions matter software on the tablet that came with the robo, one is the eeprom is not mapped on the...
    Thread by: Alex A, Aug 10, 2016, 0 replies, in forum: Troubleshooting
  9. Alex A
    Post

    Solved PTFE tube

    I think the friction will resolve itself with a few calibration runs
    Post by: Alex A, Aug 10, 2016 in forum: Troubleshooting
  10. Alex A
    Post

    Solved PTFE tube

    I can take the whole thing apart and cutt the PTFE tzube shorter there by/ reducing friction how've it willbr recest
    Post by: Alex A, Aug 7, 2016 in forum: Troubleshooting
  11. Alex A
    Post

    Solved PTFE tube

    I cut the tube flush where it exits the housing just below the feeder assembly. How do I reset the x axis to 0.00 it reads -0.70 as it is...
    Post by: Alex A, Aug 7, 2016 in forum: Troubleshooting
  12. Alex A
    Post

    Solved PTFE tube

    I'm using E3D V6 nozzle upgrade on the robo 3D R1, I set it up as per instructions on printed solid.com
    Post by: Alex A, Aug 7, 2016 in forum: Troubleshooting
  13. Alex A
    Thread

    Solved PTFE tube

    There seems to be increased friction using this tube which doesn't allow the feeder mechanism the force it needs to move the plastic into the...
    Thread by: Alex A, Aug 7, 2016, 7 replies, in forum: Troubleshooting
Showing results 1 to 13 of 13
Search Again