1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. woofguy
    Post

    Solved Z-Axis Waaaaay off!

    just wanted to thank you both for all of you help! especially @danzca6 for putting up with all my DMs and responding so quickly. i finally have my...
    Post by: woofguy, Aug 31, 2016 in forum: Troubleshooting
  2. woofguy
    Post

    Solved Z-Axis Waaaaay off!

    Ok, so that was a good exercise! I tried cutting it down to 400 and it was slooooow as dirt, BUT it seemed to change. I moved it back to 800 and...
    Post by: woofguy, Aug 28, 2016 in forum: Troubleshooting
  3. woofguy
    Post

    Solved Z-Axis Waaaaay off!

    the only thing i did to the leadscrews, is manually turn them (with power off of course) to unmount/remount the carriage. that wouldnt do this?
    Post by: woofguy, Aug 28, 2016 in forum: Troubleshooting
  4. woofguy
    Post

    Solved Z-Axis Waaaaay off!

    so than my setting of 800 is correct? any other ideas?
    Post by: woofguy, Aug 28, 2016 in forum: Troubleshooting
  5. woofguy
    Post

    Solved Z-Axis Waaaaay off!

    mine are the same EXCEPT i changed the 723.38 to 420 for the titan extruder.... i read that was right one for extruder?
    Post by: woofguy, Aug 28, 2016 in forum: Troubleshooting
  6. woofguy
    Thread

    Solved Z-Axis Waaaaay off!

    so i just installed the E3D V6 and a titan extruder in my R1+. everything went well, except got the firmware from the forum edited and uploaded....
    Thread by: woofguy, Aug 28, 2016, 16 replies, in forum: Troubleshooting
  7. woofguy
    Post

    E3D Titan Extruder Filament load

    you rock!!
    Post by: woofguy, Aug 27, 2016 in forum: Mods and Upgrades
  8. woofguy
    Post

    E3D Titan Extruder Filament load

    any update @danzca6 ?
    Post by: woofguy, Aug 27, 2016 in forum: Mods and Upgrades
  9. woofguy
    Post

    E3D Titan Extruder Filament load

    That would be amazing Danzca6! Thank you, i'm still learning the firmware stuff and i'll admit it's a bit of pain for me to wrap my head around....
    Post by: woofguy, Aug 26, 2016 in forum: Mods and Upgrades
  10. woofguy
    Thread

    E3D Titan Extruder Filament load

    HI everyone, first post on here (be gentle!) So I have two 3D printers, I have a Robo3D R1 Plus+ (my first printer) I also have an Ultimaker 2...
    Thread by: woofguy, Aug 26, 2016, 8 replies, in forum: Mods and Upgrades
Showing results 1 to 10 of 10
Search Again