1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. derek greenaway
    Post

    Answered Poor printing

    oh could heat be the problem? it looks pretty wobbly but its quite small so you can hardly notice it.
    Post by: derek greenaway, Apr 26, 2017 in forum: Troubleshooting
  2. derek greenaway
    Post

    Answered Poor printing

    Heres two pictures. This is just with default high settings which are partly made up of the settings i posted before. Increasing my overall layer...
    Post by: derek greenaway, Apr 26, 2017 in forum: Troubleshooting
  3. derek greenaway
    Post

    Answered Poor printing

    Hey, Material: PLA 1.75mm Fan settings are all at 100% Extruder Temp. is at 210 degrees C Print bed Temp. is 50 degrees C Layer Height is 0.1mm...
    Post by: derek greenaway, Apr 26, 2017 in forum: Troubleshooting
  4. derek greenaway
    Post

    Answered none of the axis will move!

    just got it working actually! managed to spin the carriage around and unscrew it and move the whole thing up a few mm. my prints are looking kinda...
    Post by: derek greenaway, Apr 24, 2017 in forum: Troubleshooting
  5. derek greenaway
    Thread

    Answered Poor printing

    Hey guys. Super new to 3D printers. The prints im getting are all stringy sorta looking and are slanting/collapsing in on themselves. i was...
    Thread by: derek greenaway, Apr 24, 2017, 10 replies, in forum: Troubleshooting
  6. derek greenaway
    Post

    Answered none of the axis will move!

    the picture should explain the reason as to why it will be hard to loosen the screw. you can see the latch isnt quite there. notice how the screw...
    Post by: derek greenaway, Apr 24, 2017 in forum: Troubleshooting
  7. derek greenaway
    Post

    Answered none of the axis will move!

    oh im dumb i think i get how to move the switch upward to the carriage now but i cant quite get the latch to grab the top lip of the carriage. it...
    Post by: derek greenaway, Apr 24, 2017 in forum: Troubleshooting
  8. derek greenaway
    Post

    Answered none of the axis will move!

    ah okay. yea i see that the switch on the right side is probably about a centimeter away from the part above. so the firmware i installed...
    Post by: derek greenaway, Apr 24, 2017 in forum: Troubleshooting
  9. derek greenaway
    Thread

    Answered none of the axis will move!

    I have the Robo1+ refurbished and it was working fine. Then after i came back from lunch the z-axis wouldn't go down. However it was still able to...
    Thread by: derek greenaway, Apr 24, 2017, 10 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again