1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. weapon121
    Post

    strange behavior - bed level

    I haven't had issues printing from Cura, with the default settings on it. Do you have the correct printer profile set up in the Cura settings?
    Post by: weapon121, Sep 13, 2018 in forum: Troubleshooting
  2. weapon121
    Post

    Strange issue after Pogo connector fail

    Just a quick update for anybody having this very same issue. It turned out being the Main Controller Board. Looks like the board went along with...
    Post by: weapon121, Sep 13, 2018 in forum: Troubleshooting
  3. weapon121
    Post

    Wrong temp readings for bed & extruder after replacing pogo pin board

    Yup, that was my issue exactly. It turned out being the main controller board. When the pogo failed, it somehow took the board along for a ride...
    Post by: weapon121, Sep 13, 2018 in forum: Troubleshooting
  4. weapon121
    Post

    Strange issue after Pogo connector fail

    Sounds good, I'll let you guys know what happens! Thx
    Post by: weapon121, Aug 6, 2018 in forum: Troubleshooting
  5. weapon121
    Post

    Strange issue after Pogo connector fail

    Ok, so the firmware update did nothing, but I went and tried the PID tuner just to try it out. The Extruder actually started to heat up this time,...
    Post by: weapon121, Aug 4, 2018 in forum: Troubleshooting
  6. weapon121
    Post

    Strange issue after Pogo connector fail

    Ill try to see if reinstalling the firmware does anything
    Post by: weapon121, Aug 4, 2018 in forum: Troubleshooting
  7. weapon121
    Thread

    Strange issue after Pogo connector fail

    Hello! :) So for the second time, my pogo board needs to be replaced. I contacted Robo and got it sorted out. I contacted Bryan directly and he...
    Thread by: weapon121, Aug 4, 2018, 7 replies, in forum: Troubleshooting
  8. weapon121
    Post

    Help! Print too low on back and too high on front! (3D printing NEWBIE)

    I thought I was the only one with this issue! I've been getting around it by printing towards the front when I can, but No matter what I try I get...
    Post by: weapon121, Jul 11, 2018 in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again