1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Jason Hopkins
    Post

    Unanswered Question on Y axis, time to learn some new stuff

    Sorry, for delay in response. I have gotten it printing better and taken pictures I need to post still. But I am using the gfx as a refernece to a...
    Post by: Jason Hopkins, Oct 17, 2021 in forum: Troubleshooting
  2. Jason Hopkins
    Thread

    Unanswered Question on Y axis, time to learn some new stuff

    Hello, All I have been working on some stuff, unfortunately don't want to mention yet. With doing this I thing I screwed up my y axis and I'm...
    Thread by: Jason Hopkins, Oct 12, 2021, 3 replies, in forum: Troubleshooting
  3. Jason Hopkins
    Thread

    Raspberry pi config for Octoprint

    Hello All, I have a little question of curiosity about Octoprint on the Raspberry PI, mainly the B+ models. What kind of setting is everyone...
    Thread by: Jason Hopkins, Nov 9, 2017, 4 replies, in forum: General Questions
  4. Jason Hopkins
    Post

    Temp issues with Robo3d and octoprint

    Thank, you for the help. I finally was able to heat up to 240 and try a abs print. I did transfer my start and end gcodes from cura over to...
    Post by: Jason Hopkins, Aug 30, 2017 in forum: General Questions
  5. Jason Hopkins
    Post

    Temp issues with Robo3d and octoprint

    Sorry, I forgot. My printer is robo3d plus, I just recent went from using matter control on a window box to getting Cura running under linux mint....
    Post by: Jason Hopkins, Aug 29, 2017 in forum: General Questions
  6. Jason Hopkins
    Post

    Temp issues with Robo3d and octoprint

    Under Gcode script in before print job starts I have nothing. My after a print job is canceled is the only block with anything in it. Im getting...
    Post by: Jason Hopkins, Aug 29, 2017 in forum: General Questions
  7. Jason Hopkins
    Thread

    Temp issues with Robo3d and octoprint

    I have been trying to print abs thru my robo3d plus and octoprint. Have not had good results yet, but I keep noticing octoprint keeps changing my...
    Thread by: Jason Hopkins, Aug 29, 2017, 8 replies, in forum: General Questions
Showing results 1 to 7 of 7
Search Again