1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Sam Ho
    Post

    Unresolved The Y-axis bell has broken

    The plastic hold the belt broke. Screw and nut to hold the plastic at the front side of the head bed lost, which is the one you can see at the...
    Post by: Sam Ho, Jul 17, 2016 in forum: Troubleshooting
  2. Sam Ho
    Post

    Unresolved The Y-axis bell has broken

    Thanks for your suggestion to contact technical support, will try. To print a new one is good, I can ask my friend to help, but one screw and nut...
    Post by: Sam Ho, Jul 17, 2016 in forum: Troubleshooting
  3. Sam Ho
    Post

    Unresolved The Y-axis bell has broken

    Oh, the bell is good, but the plastic end has broken and screw is gone.
    Post by: Sam Ho, Jul 17, 2016 in forum: Troubleshooting
  4. Sam Ho
    Post

    Solved Matter Control could not connect to printer

    Ok, I reinstall the matter control (another version), now can connect to printer.
    Post by: Sam Ho, Jul 16, 2016 in forum: Troubleshooting
  5. Sam Ho
    Thread

    Unresolved The Y-axis bell has broken

    My 3D printer Y-axis bell has broken but there is no replacement part available in ROBO shop.
    Thread by: Sam Ho, Jul 16, 2016, 7 replies, in forum: Troubleshooting
  6. Sam Ho
    Post

    Solved Matter Control could not connect to printer

    Could you kindly advise from where I can get the start up materials?
    Post by: Sam Ho, Jul 10, 2016 in forum: Troubleshooting
  7. Sam Ho
    Thread

    Solved Matter Control could not connect to printer

    I was using my pc to connect to my ROBO 3D R1 printer. Today I use my laptop but totally could my connect the printer. There is no printer for my...
    Thread by: Sam Ho, Jul 10, 2016, 5 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again