1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Joe M
    Post

    Solved Am I missing a setting?

    Yup – that was the problem. Too far from the bed. I adjusted the z-axis and all is well. Thank you for your help, gents!
    Post by: Joe M, Aug 2, 2017 in forum: Troubleshooting
  2. Joe M
    Thread

    Solved Am I missing a setting?

    1. I successfully printed an item from my SD card on my Robo R1+ and it printed fine using glow-in-the-dark PLA filament. 2. I printed an item...
    Thread by: Joe M, Aug 1, 2017, 3 replies, in forum: Troubleshooting
  3. Joe M
    Post

    Bowden Tube

    Got it - thanks. Do you think a Bowden tube and slow print is necessary when printing with a Robo R1+ using 3mm filament instead of 1.75mm?
    Post by: Joe M, Jul 27, 2017 in forum: General Questions
  4. Joe M
    Post

    Bowden Tube

    Would you recommend an oiler, too?
    Post by: Joe M, Jul 27, 2017 in forum: General Questions
  5. Joe M
    Post

    Bowden Tube

    Thanks – and this should keep the NinjaFlex from getting tangled once it enters the extruder?
    Post by: Joe M, Jul 27, 2017 in forum: General Questions
  6. Joe M
    Thread

    Bowden Tube

    Can anyone recommend an ideal Bowden tube for the Robo R1+ for printing 1.75" NijaFlex? Perhaps a link to Amazon? Thanks!
    Thread by: Joe M, Jul 27, 2017, 7 replies, in forum: General Questions
  7. Joe M
    Post

    Solved Ninja Flex filament tangled in extruder.

    Thanks for the walkthrough. That worked. I no longer hate 3D printing like I did a few hours ago. ;^D I was able to untangle the NinjaFlex...
    Post by: Joe M, Jul 26, 2017 in forum: Troubleshooting
  8. Joe M
    Post

    Solved Ninja Flex filament tangled in extruder.

    Yes, a walk though those steps would be great. My background is in software engineering, so I'm used to moving electrons, not atoms. Thanks for...
    Post by: Joe M, Jul 26, 2017 in forum: Troubleshooting
  9. Joe M
    Thread

    Solved Ninja Flex filament tangled in extruder.

    I tried using NijaFlex for the first time. When it stopped printing because the filament wasn't feeding, I called Robo3D and was told that I'd...
    Thread by: Joe M, Jul 26, 2017, 5 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again