1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. GriZag
    Post

    First look at R2 replacement board by Partsbuilt.com

    Thanks for the info. Good to hear the printer hasn't been totally forgotten!
    Post by: GriZag, Mar 22, 2020 in forum: Mods and Upgrades
  2. GriZag
    Post

    First look at R2 replacement board by Partsbuilt.com

    Are the stepper drivers any more quiet than the original R2? Plus it looks like it's still in development.
    Post by: GriZag, Mar 22, 2020 in forum: Mods and Upgrades
  3. GriZag
    Post

    First look at R2 replacement board by Partsbuilt.com

    Excellent, thanks! Been looking for a way to update my printer so I can use it again after the board pooped out.
    Post by: GriZag, Mar 22, 2020 in forum: Mods and Upgrades
  4. GriZag
    Post

    First look at R2 replacement board by Partsbuilt.com

    Any updates on the use of the board?
    Post by: GriZag, Mar 21, 2020 in forum: Mods and Upgrades
  5. GriZag
    Post

    Printer beeping I can't figure out or stop

    Thanks for the trouble shooting tips. I'll dig around in there and see if that helps figure it out. Much appreciated!
    Post by: GriZag, Jun 10, 2019 in forum: Troubleshooting
  6. GriZag
    Thread

    Printer beeping I can't figure out or stop

    For a while my pritner will make a long beeping noise while the print bed is rising to initiate a print. Wasn't a big deal and the print quality...
    Thread by: GriZag, Jun 8, 2019, 4 replies, in forum: Troubleshooting
  7. GriZag
    Thread

    Cura 3.0

    I've been using the newest version of Cura from Ultimaker because it gives the option of a gradual infill. One of the biggest benefits I've...
    Thread by: GriZag, Nov 17, 2017, 34 replies, in forum: Software
  8. GriZag
    Post

    Adding a 2nd Hot End

    There is a sign up for being notified when the dual extruder kit becomes available at robo3d.com/pages/dual-extruder-kit.
    Post by: GriZag, Nov 17, 2017 in forum: General Questions
Showing results 1 to 8 of 8
Search Again