1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Mark Gandenberger
    Post

    Solved Printer has died(?)

    Well, there's one other possibility worth considering - operator error! When I started unhooking the printer so I could replace the board I...
    Post by: Mark Gandenberger, Dec 21, 2018 in forum: Troubleshooting
  2. Mark Gandenberger
    Post

    Solved Printer has died(?)

    Based on your reply I did a little more investigating and here is the bottom line: If the printer is ON Simplify3D will not connect and does not...
    Post by: Mark Gandenberger, Dec 21, 2018 in forum: Troubleshooting
  3. Mark Gandenberger
    Thread

    Solved Printer has died(?)

    Well, I had just started a print and the printer was going through the auto-level sequence when it just stopped. I have posted a photo of what now...
    Thread by: Mark Gandenberger, Dec 21, 2018, 5 replies, in forum: Troubleshooting
  4. Mark Gandenberger
    Post

    Solved Err: MAXTEMP BED

    Well, after enduring one more setback (my new board delivered to somebody a couple houses up the street) I finally was able to install a new...
    Post by: Mark Gandenberger, Mar 22, 2018 in forum: Troubleshooting
  5. Mark Gandenberger
    Post

    Solved Err: MAXTEMP BED

    I don't think I've left anything out but that's why I figured it would be good to double check my thought process. In my mind there are only 3...
    Post by: Mark Gandenberger, Mar 21, 2018 in forum: Troubleshooting
  6. Mark Gandenberger
    Post

    Solved Err: MAXTEMP BED

    Well, my new Ramps board(s) arrived today so I immediately got working on installing a new one. I had everything but the fans and LEDs hooked up...
    Post by: Mark Gandenberger, Mar 20, 2018 in forum: Troubleshooting
  7. Mark Gandenberger
    Post

    Solved Err: MAXTEMP BED

    Thanks! Robo has the Ramps+Arduino for $100 and that seemed pretty expensive for the convenience of drop-in replacement, especially if it's...
    Post by: Mark Gandenberger, Mar 19, 2018 in forum: Troubleshooting
  8. Mark Gandenberger
    Thread

    Solved Err: MAXTEMP BED

    So, I had just finished one print and was getting ready to start a second when I got a MAXTEMP BED error. The bed temp reads 233. The temperature...
    Thread by: Mark Gandenberger, Mar 19, 2018, 13 replies, in forum: Troubleshooting
  9. Mark Gandenberger
    Post

    Silver Filament

    That might be like trying to remember what it was like having all my hair, but I'll give it a try! Thank you for the link!
    Post by: Mark Gandenberger, Dec 11, 2017 in forum: Printing Filament
  10. Mark Gandenberger
    Post

    Silver Filament

    Thanks for the replies. Sounds like I might need to hunt for the airbrush I haven't used in 30 years! ;-)
    Post by: Mark Gandenberger, Dec 11, 2017 in forum: Printing Filament
  11. Mark Gandenberger
    Thread

    Silver Filament

    Can anyone recommend a good looking silver filament? I recently picked up some Silver Metal PLA filament from 3D Solutech. It worked okay but it...
    Thread by: Mark Gandenberger, Dec 11, 2017, 8 replies, in forum: Printing Filament
Showing results 1 to 11 of 11
Search Again