1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Matt Brenner
    Post

    Solved Robo 3D R1 Plus knocked print job out of place

    Hi there again. while looking at the z offset and other settings I noticed the setting for the filiment type. Well I checked and it was wrong....
    Post by: Matt Brenner, Dec 15, 2017 in forum: Troubleshooting
  2. Matt Brenner
    Post

    Solved Robo 3D R1 Plus knocked print job out of place

    I will post a video when i get a chance soon. Meanwhile, I think the Z-Offset is the problem granted I might just not know. But I'm not sure how...
    Post by: Matt Brenner, Dec 15, 2017 in forum: Troubleshooting
  3. Matt Brenner
    Post

    Solved Robo 3D R1 Plus knocked print job out of place

    Hello again and sorry for the late reply. I cleaned the glass plate bed. It had a lot of plastic and glue left on it from being used a lot and not...
    Post by: Matt Brenner, Dec 15, 2017 in forum: Troubleshooting
  4. Matt Brenner
    Thread

    Solved Robo 3D R1 Plus knocked print job out of place

    I have had a few problems with this printer starting this year and they may or may not be related to my current problem. First the plastic wasn't...
    Thread by: Matt Brenner, Dec 8, 2017, 8 replies, in forum: Troubleshooting
  5. Matt Brenner
    Post

    Solved Robo 3D R1 Z-Axis home is way off

    Here is an update: I did find the little Z-Switch was off and by twisting the bar it was on I got it leveled out and working.
    Post by: Matt Brenner, Dec 8, 2017 in forum: Troubleshooting
  6. Matt Brenner
    Post

    Solved Robo 3D R1 Z-Axis home is way off

    Thank you for the advice. I don't know what the z switches are so I will watch the tutorial Mark provided and post my results.
    Post by: Matt Brenner, Dec 7, 2017 in forum: Troubleshooting
  7. Matt Brenner
    Thread

    Solved Robo 3D R1 Z-Axis home is way off

    Hello and thanks for any help. I work at an elementary school. Their 3D printer had been working for a few years. Lately the extruder had been...
    Thread by: Matt Brenner, Dec 6, 2017, 6 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again