1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. jappenzeller
    Post

    Removing Prints

    Using PLA.
    Post by: jappenzeller, May 10, 2018 in forum: Troubleshooting
  2. jappenzeller
    Post

    Removing Prints

    Thanks for the help, I'll try this out. Found some on amazon.
    Post by: jappenzeller, May 10, 2018 in forum: Troubleshooting
  3. jappenzeller
    Post

    Removing Prints

    Are you able to reuse them or do you have to throw away with each print?
    Post by: jappenzeller, May 10, 2018 in forum: Troubleshooting
  4. jappenzeller
    Post

    Removing Prints

    Where would I get something like that?
    Post by: jappenzeller, May 10, 2018 in forum: Troubleshooting
  5. jappenzeller
    Thread

    Removing Prints

    My prints are hopelessly stuck to the bed, I've had the printer a week and I've already got a small gouge on the bed due to trying to get a print...
    Thread by: jappenzeller, May 9, 2018, 9 replies, in forum: Troubleshooting
  6. jappenzeller
    Post

    Strings and Poor Detail

    Thanks for all the replies. Gonna keep experimenting. :)
    Post by: jappenzeller, May 6, 2018 in forum: Troubleshooting
  7. jappenzeller
    Post

    Strings and Poor Detail

    Thanks for the comments, reducing the temperature did help a little with the strings, but it turns out the Wipe Nozzle setting was causing most of...
    Post by: jappenzeller, May 6, 2018 in forum: Troubleshooting
  8. jappenzeller
    Post

    Strings and Poor Detail

    The temperature is slightly lower than what I had with the R1 , but I'll try dropping it some more. What is a temperature test tower?
    Post by: jappenzeller, May 5, 2018 in forum: Troubleshooting
  9. jappenzeller
    Thread

    Strings and Poor Detail

    I've been using my r1+ for almost a year and the quality was really good. I just got my R2 and I've tried a few prints and I'm getting a lot of...
    Thread by: jappenzeller, May 5, 2018, 13 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again